3018 PROVer Cnc Dust Boot

This is a dustboot that I designed for the Sainsmart 3018 PROVer. It should also fit any 3018 cnc that uses a 775 spindle motor.

It should be opened with carbidecreate

The video below shows how it is glued together.

4 thoughts on “3018 PROVer Cnc Dust Boot”

Steve April 15, 2021 at 7:23 pm

Thank you.

Reply ↓
Robert c Glen July 20, 2021 at 6:45 am

Could you please help me I’m trying to figure out how to set the travel limits I did the upgrade to the bigger deck on my 3080 Prov to the bigger deck bigger spindle but I don’t feel I have the G code sender correctly set up if you could please direct me out where I could get information about that I’d be very thankful.

Reply ↓
Federico September 30, 2021 at 9:54 am

Thank you! Great site and channel

Reply ↓
Gérard December 16, 2022 at 4:04 pm

Merci

Reply ↓