Eleksmaker EleksLaser A3 Pro Laser Engraver 2500mW – Review, build and Test

Review, build and test of the Eleksmaker EleksLaser A3 Pro laser engraver.

EleksMaker® EleksLaser-A3 Pro: https://goo.gl/Rb4coH

To engrave the mirror in the video I used Inkscape (which is a free opensource vector graphics editor) and the excellent  Inkscape laser plugin

You can download the SVG file here    Avengers A3 V3 SVG (41 downloads)   (You should flip this image if you are engraving a mirror from the back)

  • The power was set to full and the feed rate to 600 mm/min with 3 passes.
  • Remember to reverse the image as the back (painted side) of the mirror is engraved.
  • To finish, wash the mirror with dish soap using a tooth brush to clean the engraved lines.

Leave a Reply